Features
• Steel, galvanized
• Combines the advantages of an anchor bolt's operating principle with those of simple hammer-in installation
• No tightening torque required for the anchor expansion
• Expands automatically under load. The cone is thus pulled into the expansion clip and presses it against the wall of the drill hole
• Secures suspended ceilings, cable trays, wall linings, fire protection plates, etc.
Approved for:
• Use as multiple (redundant) fastening of non-load-bearing systems in cracked concrete C12/15 to C50/60, also in the tension zone
Also suitable for:
• Dense natural stone
• Solid sand-lime brick
• Pre-stressed hollow-core concrete slabs
For fastening of:
• Battens
• Metal profiles
• Wire and vernier hangers
• Chains
• Perforated strips
• Fire-stops
• Fire protection linings
• Ventilation ducts
• Wood and metal substructures
• Ceiling linings
• Metal clamps
• Plasterboard
Advantages:
• Very simple installation: drill, hammer - done!
• Only 2 to 4 hammer blows and the FNA II is in place
• Also suitable for attached components with lower compressive strength (wood, plaster, ...)
• Minimum anchorage depth of only 30 mm reduces drilling time - saving time and reducing the risk of hitting rebar
• Maximum tensile capacity up to 2.4 kN allowable load
• Small axial and edge distances for applications even on small building elements (e.g. on beams only 10 cm wide)
• For element thicknesses from 8 cm
• The usual load tests are no longer necessary!
• First ceiling anchor with European Technical Approval in low-strength concrete C12/15 (B15)
• Through-hole installation
• Drill bit Ø: 6 mm
• Min. anchorage depth: 30 mm
• Head Ø: 13 mm
Packaged and sold per full box (quantity indicated in the configuration).
Available variants
- SKU 94 122 72 : Ø6x25 mm · clamping 5 mm · Box of 100 pieces — 55.80 CHF
- SKU 94 012 36 : Ø6x30 mm · Box of 100 pieces — 50.70 CHF
- SKU 94 122 73 : Ø6x30 mm · clamping 30 mm · Box of 50 pieces — 38.20 CHF
Technical data sheets
